Aeg Washing machine that will not empty. How to replace Aeg Washing machine pump

Here is a step by step guide of the process:

How to replace Aeg Washing machine pump that will not empty.

If your Aeg Washing machine will not empty then this video will help you.

This tutorial will show you what to do if the Aeg washing machine does not drain or empty the water out, this repair was done on a Aeg 8kg washer dryer appliance.

Click here for all Aeg washing machine pumps:

After checking that the Aeg pump is faulty in our previous tutorials you will need to replace the old washing machine pump with a new one. Disconnect the appliance from the electricity supply by removing the plug.

  • You have two ways that this can be done, you can replace from the bottom of the machine if there is no base plate fitted, or you can take the front of depending on your model.
  • Once you have gained access to the pump you will need to remove the hoses from the pump by undoing the clips, which will be one of two type jubilee type or clapped type.
  •  Disconnect the wires that are attached to the pump and take note of which terminals they came off. (Taking a photo is always a good way).
  • You will need to remove the bolts or clips that hold the pump in place.
  • You will need to follow previous steps to replace the new Aeg pump.

 


Grab the necessary parts and start repairing



6 Responses to “Aeg Washing machine that will not empty. How to replace Aeg Washing machine pump”

  1. how-2-repair.com says : Reply
  2. Dremdosh says : Reply

    Many thanks for this very clear video, it probably saved me a lot time and
    money!

  3. Fabio Lucarelli says : Reply

    I would like to express my gratitude for your outstanding video which
    helped me to replace a pump in less than one hour.

  4. Geoff Curtis says : Reply

    Helpful video, thank you.

  5. Bjørn Simonsen says : Reply

    Im not so technic to washing machines. But my washing machine keep blinking
    red in start/stop button. I have zanussi model zwg 3125. And even I have
    clean the filter at the bottom, and empty the water through the hose. It
    still blink red with the next wash process. Under 1 wash process I need to
    press the start button 3-4 times before it really stop. And I dont know
    what is wrong?

  6. Hada Darius says : Reply

    Thanks ! very useful !

Leave a Reply

TOP

Social Widgets powered by AB-WebLog.com.